V64 - Platform lift for wheelchairs with straight rails.                       

COMPLIANCE:
Meets or exceed the requirements of the Australian Lift Code AS1735.7 

VERSION: 
Left or right (looking from downstairs: left hand, when the rail is on the left of the staircase; right hand when the rail is on the right).

INSTALLATION: 
Suitable for indoor and outdoor use (in the latter case the rails are cold galvanized and electroplated). If required, a water proof PVC cover may be provided.

COLOUR: 
Unit white RAL 9018; black dull rail.

GRADIENT: 
From 0° to 45°

RAIL: 
Twin rail made of elliptical section tube (drilled with sprocket holes) with max length of 20 m.

MIN STAIRCASE WIDTH: 
Please contact us to discuss.

PLATFORM LANDING AREA: 

Please contact us to discuss. 

MIN RAIL WIDTH ON THE STAIRCASE: 
100 mm (nominal)

MIN PLATFORM WIDTH WHEN FOLDED: 
370 mm. minimum

FASTENINGS: 
If required by means of posts, which can be secured to the steps and tied back to a wall or to a banister by means of fixings or others; if required, self supporting structure. Standard, to the wall, with expanding anchors.

MOTOR: 
0,75 Kw mounted ON BOARD THE LIFT, fitted with an electromechanical brake with manual override for use in the event of power failure.

SAFETY ALONG THE TRACK: 
The lift is fitted with safety edges to minimise the risk of injury due to TRAPPING, CRUSHING or SQUASHING. On request a safe edge is available on the back of the unit; acoustical movement signal; fixed blinking –light.

VOLTAGE: 
230V single phase supply for main circuits; 24V dc for controls and sub-circuits, obtained by means of an on board transformer. Mains power supply by cable in protected chain.

SAFE WORKING LOAD: 
Gradient up to 45° - 230kg

CONTROLS: Constant pressure type, type fitted as standard; on board, on the attendant remote control, there are the up/down push-buttons and an on/off key switch. On request, call-send floor controls with up/down push-buttons, key switch, at landings. Opening/folding of the platform. Platform motion in work position fitted as standard.

MANUAL OPERATION ALWAYS FITTED AS STANDARD:
To be used ONLY in an emergency by persons instructed in the safe operation of the lift.

SAFETY: 
The lift uses LOW VOLTAGE CONTROLS, is fitted with SAFETY GEAR, automatic SAFETY ARMS (automatic, blocked and independent), AUTOMATIC RAMPS for wheelchair which lower at relevant level to permit transfer to the landings. Fixed HANDLE; EMERGENCY STOP BUTTON, located on the control, must be manually reset; safety TERMINAL SWITCH and FINAL LIMIT SWITCH.

TRANSMISSION: 
Direct drive via a NON-REVERSIBLE REDUCTION GEARBOX driving a pinion.

PLATFORM:
Manually operated type (gas strut assisted to reduce the effort of operation). Platform dimensions 830x700 mm. Fitted with AUTOMATIC RAMPS. On request, POWER FOLDING PLATFORM. A range of alternative widths or special dimensions are available if required.

SAFETY GEAR: 
The system incorporates an OVERSPEED GOVERNOR which is independently driven by the lower rail and initiates PROGRESSIVE BRAKING, stopping the lift in the event of a failure within the drive chain, without using any of the drive components. The whole mechanism acts on ITS OWN PINION and ON ITS OWN RAIL, which are independent from the driving one.

STANDARD FINISH: 
White powder coated chassis (RAL 9018); the standard rail is black (RAL 9005). For external use the rail is electroplated and finished in black. The lift is fitted with an ABS chassis and stainless steel bolts as standard.

For further technical information, please contact one of our experienced sales consultants.

Note: Easy Living Home Elevators Pty Limited reserves the right to make changes to the above specifications and information at any time, without notice.